SAFETY PRECAUTIONS
The
following symbols appear
in
this manual to call attention
to and emphasize conditions potentially dangerous to the
operator.
IWARNINGI
The
above symbol is used in the manual to
warn
of possible
serious personal injury or loss of life.
CAUTION
The
above symbol is used in the manual to caution personnel
of possible damage to equipment.
Read
the manual carefully and thoroughly before attempting
to operate the equipment.
Know
when dangerous conditions
can
exist and take necessary precautions to protect personnel
and equipment.
Fuels,
exhaust gases, batteries, electrical equipment, and
moving and hot parts
are
potential hazards that could result
in
serious personal injury or death. Follow recommended proce-
dures carefully.
Always operate bilge
blowers for at least five minutes before
starting a
gasoline-fueled engine; ensure no gasoline fumes
are
present before starting.
• Prevent Electric
Shock
Shut off electric power before accessing electrical equip-
ment.
Use
insulated mats whenever working
on
electrical equip-
ment.
Make
sure your clothing is dry, not damp (particularly
shoes), and keep your skin surfaces dry when handling
electrical
equipment.
Remove
wristwatch and jewelry when working
on
electri-
cal
equipment.
Do
not connect utility shore power to vessel's
AC
circuits,
except through a ship-to-shore
double-throw transfer
switch. Damage to
vessel's
AC
generator may result if this
is not done.
Be
extremely careful when working
on
electrical com-
ponents. High voltage
can
cause injury or death.
• Exhaust Gases Are
Toxjc
Ensure
that the exhaust system is adequate to expel gases
discharged from the engine. Check exhaust system
regularly for leaks and make sure the exhaust manifolds
are
securely attached and no warping exists.
Be
sure the unit and its surroundings
are
well-ventilated.
• Use Extreme Care When Handling Engine Fuel
(A constant
danger
of
explosion
or
fire exists)
Do
not fill fuel tank(s) while the engine is running.
Do
not smoke or
use
an
open flame near the engine or the
fuel tank.
•
Do
Not
Alter
or
Modjfy
the
Fuel System
Be
sure all fuel supplies have a positive shut-off valve.
Be
certain fuel line fittings
are
adequately tightened and
free of leaks.
Make
sure a fire extinguisher is installed nearby and is
properly maintained.
Be
familiar with its proper
use.
Ex-
tinguishers rated
ABC
by the
NFPA
are
appropriate for all
applications encountered
in
this environment.
• Use Extreme Care When Servicing Batterjes
Wear
rubber gloves, a rubber apron, and eye protection
when servicing batteries.
Lead
acid batteries emit hydrogen, a highly-explosive gas,
which
can
be ignited by electrical arcing or by a lighted
cigarette, cigar, or pipe.
Do
not smoke or allow
an
open
flame near the battery being serviced. Shut off all electrical
equipment
in
the vicinity to prevent electrical arcing
during servicing.
• Avoid Moving Parts
Do
not service the unit while the unit is running; if a
situation arises in which it is
absolutely necessary to make
operating adjustments, use extreme
care
to avoid moving
parts and hot exhaust system components.
Do
not wear loose clothing or jewelry when servicing
equipment; avoid wearing
loose jackets, shirts or
sleeves,
rings, necklaces, or bracelets that might be caught in
moving parts.
Make
sure all attaching hardware is properly tightened.
Keep
protective shields and guards in their respective
place at all times.
Do
not check fluid levels or the drive-belt's tension while
the unit is operating.
Do
not work
on
the equipment when mentally or physically
incapacitated by fatigue.
To Next Page
Loading...
Need help?
General
