Western HTS - Page 66

Lit. No. 49513, Rev. 00 67 August 15, 2011
OPERATING YOUR SNOWPLOW
Adjustment Procedure
1. Lower the blade to the ground before making
any adjustment.
2. Remove the hydraulic unit cover according to
the instructions for your blade:
HTS™ Blades: Remove the hydraulic unit
cover.
MVP PLUS™ and WIDE-OUT™ Blades: Lift
the hydraulic unit top cover retainer, remove
the bottom cover retainer and remove the side
cover.
Straight Blades: Follow the "Straight Blade
Hydraulic Unit Cover – Remove and Replace"
procedure in the Maintenance section of this
manual.
3. Turn the quill IN (clockwise) to decrease drop
speed. Turn the quill OUT (counterclockwise)
to increase drop speed.
4. Stand 8' clear of the blade drop zone when
checking adjustment.
5. Repeat Step 2 to reinstall the cover.