Westinghouse iGen5000 User Manual

12 | English
NOTICE
Fuel can damage paint and plastic. Use caution when
lling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
NOTICE
Clean the fuel screen lter of debris before and after
each fueling. Remove the fuel screen lter by slightly
compressing it while removing it from the fuel tank.
CONNECT THE BATTERY
1. Push down the battery access cover tab and pull the
cover forward to remove it.
2. Verify that the rubber battery strap is rmly securing the
battery in place. If loose, pull on the strap and hook it
onto the mounting base.
Note: If the strap is loose behind the battery, remove the
battery, reconnect the strap, replace the battery,
then thread the strap under the battery quick
connect cables.
3. A quick-connect battery plug is pre-installed on the
battery. Remove the cable tie securing the plugs then
push rmly to connect them.
4. Align the tabs on the bottom of the battery access cover
with the generator case then push to reinstall the cover.
Note: The generator is equipped with a battery charging
feature. Once the engine is running, a small charge
will slowly recharge the battery.
ASSEMBLY

Westinghouse iGen5000 Specifications

General

Starting Wattage	5000 Watts
Engine Type	4-Stroke OHV
Engine Displacement	224 cc
Fuel Type	Gasoline
Run Time at 25% Load	18 hours
Voltage	120V
Frequency	60 Hz
Starting Method	Recoil Start
Warranty	3 Years
Running Wattage	4500 watts
Fuel Tank Capacity	3.4 gallons