Westinghouse iGen11000DFc User Manual (English)

Other manuals for Westinghouse iGen11000DFc

Questions and Answers:

M
Michael DavisAug 7, 2025
Why won't my Westinghouse iGen11000DFc start?
- S
  Shelby JohnsonAug 7, 2025
  Your Westinghouse Portable Generator might not start due to several reasons: it could be out of fuel, the gasoline might be stale, or the air filter could be dirty. Also, check if the low oil level has stopped the generator. If the spark plug is wet with fuel, wait five minutes, turn the engine/fuel control switch to the OFF position, and pull the recoil handle rapidly several times; if this doesn't work, remove and dry the spark plug. The spark plug itself might be faulty, fouled, or improperly gapped, so gap or replace it. Finally, ensure that the CO sensor hasn't been removed or modified and return it to its original configuration.
E
Emily CastilloAug 13, 2025
How to fix a Westinghouse iGen11000DFc Portable Generator that starts then shuts down?
- M
  Miranda ChavezAug 13, 2025
  If your Westinghouse Portable Generator starts and then shuts down, it could be due to a few reasons. First, check if the fuel level is low or depleted and refuel if necessary. Also, verify the engine oil level and add oil if needed. A dirty air filter could also be the cause, so clean it. Another possibility is contaminated gasoline; in this case, drain the fuel tank and refuel with fresh gasoline.
J
Jessica ConradAug 18, 2025
What to do if my Westinghouse iGen11000DFc Portable Generator engine lacks power?
- T
  Thomas JohnsonAug 18, 2025
  If your Westinghouse Portable Generator engine lacks power, start by checking the air filter and clean or replace it if it's restricted. Stale gasoline could also be the culprit; drain the fuel tank and refuel with fresh gasoline.
J
Jake WhiteAug 26, 2025
What to do if Westinghouse Portable Generator engine runs rough or bogs when load applied?
- M
  Monique MillerAug 26, 2025
  If your Westinghouse Portable Generator engine runs rough or bogs when a load is applied, the air filter might be dirty, so clean it. The generator could also be overloaded, so unplug some devices. Another possibility is a faulty power tool or appliance, in which case you should replace or repair it and then stop and restart the engine.
G
gballardAug 31, 2025
Why is there no power at the AC receptacles on my Westinghouse iGen11000DFc Portable Generator?
- F
  fpooleAug 31, 2025
  If there's no power at the AC receptacles of your Westinghouse Portable Generator, check if the OUTPUT READY LED is OFF and the OVERLOAD LED is ON, and verify the AC load before restarting the engine. Inspect the air inlet and restart the engine. Also, check if the AC circuit breakers have tripped and reset them if necessary. A faulty power tool or appliance could also be the cause; replace or repair it and then restart the engine.

Westinghouse iGen11000DFc Specifications

General

Starting Wattage	11000 Watts
Peak Watts (Gasoline)	11000 Watts
Fuel Type	Gasoline/Propane
Run Time at 50% Load (Gasoline)	12 Hours
Wheels	Yes
CO Sensor	Yes
Transfer Switch Ready	Yes
Engine Type	457cc 4-Stroke OHV
Fuel Tank Capacity (Gasoline)	6.6 Gallons
Run Time at 50% Load (Propane)	7 hours
Weight	218 lbs
Outlets	1 x 12V DC
Starting Method	Electric Start
Warranty	3 Years