Basic Operation
Left and right stick mode replacement method
It is not recommended to replace the left and right sticks by yourself, otherwise the transmitter may be
damaged.
1 Loosen the bearing housing screws (the screws do not need to be fully retracted), then remove the
spring, bracket 7 and bracket 5 and tighten the screws; then remove the removed spring, bracket 7 and
bracket 5 in another assembly corresponding position (remove the bearing housing screw before
assembly),The tightness of the stick can be changed by adjusting the height of screw 3.
Required tools: 3 mm cross screwdriver, 1.5 mm hex driver
Firstly open the transmitter housing and then follow the instructions shown below:
2 Remove the screw of the throttle reed, the throttle reed and the throttle sleeve, and install them in the
corresponding position of the other assembly. According to your own habits, select the type of throttle
sliding (toothed and smooth) and adjust the screw (screw 1 or The height of the screw 2) makes the
damping of the throttle conform to your own habits.
Screw 2
Throttle reed Throttle sleeve
After the throttle structure is modified, turn on the machine, enter [system setting] → [stick mode], select
the corresponding operation mode, and then adjust the stick after replacing the left and right modes! If you
need components such as bracket 5 (such as the parts needed for assembling double circuit structure!), you
can e-mail to WFLY overseas seller to order the spare parts at sales@wflysz.com.
Bracket 5
Bracket 7
Spring
Throttle sleeve
Screw 1
①
Screw 3
Screw 3
Bearing
housing screw
14
To Next Page
Loading...