SERVO REVERSE
Click the reverse
operation and pop-up
the confirm window.
Before reverse
(Positive)
After reverse
(Negtive)
Interface path: HOME/MON. → [GENERAL MENU] → [SERVO REVERSE]
In some airplane/glider mixing settings, multiple servos control the same function. Whether to reverse
the airplane or reverse the function setting is very complicated and difficult to distinguish. For specific
functions, be sure to perform adequate physical inspection before flying.
For helicopters with a swash structure (HR-3, etc.), first use [Servo Reverse] to match the direction of the
pitch servo, and then use the swash AFR function to set the direction of the ailerons and elevators.
This function reverses the direction of motion of each channel servo.
47
GENERAL MENU
The throttle channel (3CH) is
reversed at the initial setting.
Connecting a propeller or a rotor can easily
cause accidental rotation and lead to serious
dangers such as injury.
Please carefully check the throttle direction of the
engine and motor, taking care not to suddenly turn
on the power at full speed. When using an electric
model, please do not care if the propeller or rotor is
not installed.Identify the direction of movement of
the electric and stick.
Before each flight, carefully
check whether the system type,
model type, steering action, direction of motion,
and switch settings are correct or not.
To Next Page
Loading...