RECEIVER OUTPUT
All ports of RF206S can be customized channels, but PPM and W.BUS can only be set to the 6th
port.
Note: [RECEIVER OUTPUT] needs to be set with only one receiver connected.
This function is used to customize the port output function channel of the receiver. For the corresponding
channel function, please go to [Function] of [General Menu] to set.
Different receivers will have different Settings and the default Settings will be different.
Interface path: HOME/MON. → [LINKAGE SETTING] → [RECEIVER OUTPUT]
Port setting instructions:
1 As shown above, port 1, the system defaults to channel 1, you can also set to 2-18 channels.
2 The Reset button resets all ports to their default configuration.
*Set the receiver to be connected, enter the interface to read the current receiver parameters, exit
the interface and save the current receiver settings.
Mode A (RF209S) Mode B (RF209S)
38
LINKAGE SETTING
To Next Page
Loading...