ElE TO CAMBER
Interface path: HOME/MON. → [MODEL MENU] → [ELE TO CAMBER]
Use this function when you need to mix flap operation and elevator operation. When the mixing control is
turned on, the elevator will be raised while the flap is lowered, which can increase the lift.
Function status switch (INH, ON, default [INH])
Control switch assignment, default [--]
This function can be switched "on" or "off" with the switch during flight. (If you want to keep it on, set it to
[--], you can also set it to [--], and the position is "On" to achieve the function normally open.)
When the mixing is activated, the elevator on the tailless wing is also affected.
Adjust in the positive and negative directions,
range ±100%, default 0%
72
MODEL MENU \ AIRPLANE
To Next Page
Loading...