WINGLET
Interface path: HOME/MON. → [MODEL MENU] → [WINGLET]
This function is used to adjust the left and right rudder of the model winglet. The winglet is used to reduce
the induced drag caused by the wing tip vortex. (Winglets are vertical or angled extensions at the end of
each wing.)
The winglets can significantly increase the wing's aspect ratio without increasing the structural stress
and weight of the wing. Although increasing the span is also able to reduce the induced drag, it also
introduces parasitic drag and requires more power to support the weight of the wing, which results in no
overall savings. The winglet can help solve this problem, it increases the aspect ratio, but does not
increase the wing's wingspan.
Function state switch (INH, ACT, default [INH])
● When the connection causes the mixing direction to be reversed, it can be adjusted by changing the
● The amount of operation of each servo can be adjusted separately. (For the connection method of the
steering gear, please refer to "Servo connection in different model categories")
polarity (+/-) of the action amount.
● When the amount of action is too large or the rudder is repeated, the servo may not respond. Be sure to
confirm the actual movement of the body when setting
Adjust the action amount of rudder respectively,
the default is 100%
Rudder
(Winglet)
Tailless aircraft
Rudder2
(Winglet)
Tailless aircraft
73
MODEL MENU \ AIRPLANE
To Next Page
Loading...