SUB-TRIM
Interface path: HOME/MON. → [GENERAL MENU] → [SUB-TRIM]
This function is a function to trim the neutral position of each servo. In addition, the neutrality of the
rudder surface can be trimmed while the connecting rod is connected.
When starting the [Sub-trim] setting, you must firstly sub trim each channel (checked by the monitor) to
the center position.
Before adjusting [Sub-trim], be sure to adjust the control surface (servo)control link on the model firstly,
and then use the [Sub-trim] function.
Trave: -240~+240
52
GENERAL MENU
To Next Page
Loading...