GYRO
This function is used to adjust the gyroscope sensitivity. Set the sensitivity and mode of operation
(normal/AVCS) for each flight condition or switch.
Interface path: HOME/MON. → [MODEL MENU] → [GYRO]
Condition
mode
Switch
mode
The control gyro sensitivity can be activated by "Fly
Condition" or by assigning switches, knobs, and so on.
3 modes can set the sensitivity separately
A switch, knob, etc. can be set to activate the sensitivity
value of the specified position of the switch.
Normal mode, (AVCS) locktail mode.
Set the associated tuning control switch, knob, etc. for
sensitivity adjustment
Gyro operation mode. Normal, AVCS100%
Can set the trim range value ±20%
Control switch current real-time position
Disable and enable the current Gyro configuration group.
Each control switch may be provided gyro respectively,
three kinds of sensitivity can be provided.
5 Type selecting. Select the sensitivity type of the corresponding work for the current "position".
The sensitivity required for different flight modes is different, so switch the conditions (Position)
separately for sensitivity adjustment.
7 Trim the switch selection and trim the ratio setting. Sensitivity tuning switch, the default is [--]; the rate
value can be set to ±20%. Used for trimming the sensitivity.
1 When using the function, first assign the function channel on the [Function] interface, and set the
"Switch” and “Trim” to [--] in [Function].
Function setting
4 Status selecting. Select whether the "Position" configuration above is enabled or not.
2 Mode selecting. Optional "switch" or "Fly condition".
3 Position selecting. In each mode, there are 3 groups of positions to choose from, and the
corresponding sensitivity can be set separately. In the "switch" mode, you need to select the position
switch, the default is [--].
6 Ratio adjustment. The options vary depending on the type option ("Normal" type, "Rate" range 0%-
100%; under "AVCS" type, "Rate" range is Normal[0~100%], AVCS[0~100%]) .
62
MODEL MENU \ HELICOPTER
To Next Page
Loading...