07
2.3 Installing the Handlebar set
2.2 Installing the pedals
Before installing the pedals, please check each for a
small letter to indicate which side of the bike the pedal
should be attached to. is for the left side while
is for the right side (fig.4).
With the kickstand holding your E-Bike upright, screw the
pedals onto the crank arms (fig.5) and tighten them with
the included wrench.
fig.5
L
R
fig.4
L
R
1. Loosen the screw of the handlebar stem first，and then turn the
handlebar stem forward，as shown in the following figure:
To Next Page
Loading...