PA
GE 8
FOR SERVICE TECHNICIAN’S USE ONLY
DO NOT REMOVE OR DESTRO
Y
QUICK OVERVIEW TEST MODE — See page 4 to access Quick Overview Test Mode. =
ON
Press the START button to begin the Quick Overview T
est. IMPORTANT: Lid must be closed and locked to perform
Quick Overview Test.
FUNCTION
Recommended Procedure
(Status LED names may vary between makes and models)
SOAK/
WASH
RINSE
FINAL
SPIN
DONE
LID
LOCKED
LID WILL
LOCK
On
COLD VAL
VE WILL ACTUATE
On
HOT VAL
VE WILL ACTUATE
On
SHIFTER MOVES TO
AGITATION POSITION
On
MOTOR
AGITATES
On
DRAIN PUMP WILL
ACTUATE
On
SHIFTER MOVES TO SPIN POSITION
On
MOT
OR SPINS
On
LID REMAINS LOCKED UNTIL WASHER SENSES A ST
OPPED
BASKET
On
LID WILL
UNLOCK AND CYCLE COMPLETES
STATUS LEDs
If motor does not agitate, go to Manual Overview Test: Gentle or Heavy
Agitation, page 9.
If water is not draining, go to Manual Overview Test: Drain, page 9.
Motor must be at “0” RPM. If lid does not lock, go to Manual Overview Test: Lid Lock, page 9.
If water is not present, or temperature is wrong, go to Manual Overview Test: Cold Valve, page 9.
If lid does not unlock, go to Manual Overview Test: Lid Lock, page 9.
If water is not present, or temperature is wrong, go to Manual Overview Test: Hot Valve, page 9.
Basket must stop spinning (0 RPM) before test continues to next phase. Time for basket to stop spinning may vary
from 30 seconds up to 2 minutes.
If basket is not turning, go to Manual Overview Test: Low or High Spin, page 9.
Est. TIME
In Seconds
1
60
10
~5-15
10
Till Empty
~5-15
10
~30-45
1
~3 min
1
2
21
4
4
1
4 2
4 2 1
8
81
8 2
To Next Page
Loading...
