26
COMPONENT
KEY PAD DISPLAY CONTROL ACTION
Neutral Drain
/Spin Test
T 4T 4
T 4T 4
T 4
T 4T 4
T 4T 4
T 4
T 4T 4
T 4T 4
T 4
T 4T 4
T 4T 4
T 4
T 4T 4
T 4T 4
T 4
PERMANENT
PRESS
repeat
repeat
repeat
repeat
Motor drains at high speed
Motor drains at med speed
Motor drains at low speed
No action
Exit test
Pressure
Transducer/
Agitate Test
ERER
ERER
ER
T 3T 3
T 3T 3
T 3
T 3T 3
T 3T 3
T 3
T 3T 3
T 3T 3
T 3
T 3T 3
T 3T 3
T 3
T 3T 3
T 3T 3
T 3
E RE R
E RE R
E R
T 3T 3
T 3T 3
T 3
T 3T 3
T 3T 3
T 3
NORMAL
repeat
repeat
repeat
repeat
repeat
Hot, cold and fresh water valves are on until a
low water level is reached, and the small load
water level LED comes on.
Agitation occurs at high speed. The small load
LED is on.
Agitation occurs at med. speed. The small load
LED is on.
Agitation occurs at low speed. The small load
LED is on.
Agitation stops, and the large load water level
LED comes on.
Hot, cold and fresh water valves come on. The
large load water level LED is on.
“
ERER
ERER
ER” appears when water reaches full level.
Motor agitates at low speed and the large load
water level LED is on.
Agitation stops. The large load water level LED
is on.
Exit test
SERVICE DIAGNOSTIC TESTS
CONSOLE SWITCHES AND INDICATOR TEST
To start the test press the following touchpad sequence within five (5) seconds:
WASH/RINSE > ACCUWASH > WASH/RINSE > ACCUWASH
• Press the START pad. All LEDS should light and the display should show “
8888
8888
88”.
• Each touchpad controls the LED next to it.
repeat
To Next Page
Loading...
