Whirlpool CCW5264EW0 - Page 9

- - . . ..n . . . . . . . .
5.
6.
7.
8.
I urn me water Level selector fo me
setting that corresponds with the size
of your wash load.
l To change the Water Level setting after
the washer has started to fill, turn the
selector to the desired new setting.
Select a wash-rinse temperature with
the Temperature selector. Match the
water temperature with the type of
fabric and soils being washed.
l See page 18 for water temperature
guidelines.
l Set the Temperature Selector to
Warm/Warm or to Warm/Cold.
Water temperature adjustment:
Adjust water temperature as follows:
l Wash water: Adjust faucets for wash
temperature prior to the fill for wash.
l Rinse water: Adjust faucets for rinse
temperature prior to the fill for rinse.
Turn Cycle Selector Knob to the
desired setting. See page 10.
Push the Start/Pause button to start
washer.
l The Cycle Selector Knob will NOT
rotate as the cycle progresses.
l The Cycle Status lights indicate the
operation being performed within
the cycle.
l When the cycle is complete, all Cycle
Status lights will be Off.
NOTE: Once a cycle has been started, the
Cycle Selector Knob MUST be turned to Off
before a new cycle can be selected.
9