How to fix a Whirlpool CFCR80221 Washer that does not turn on?
If your Whirlpool Washer isn't turning on, make sure the plug is fully inserted into the electrical outlet. Also, check to see if there has been a power failure.
Why won't the wash cycle start on my Whirlpool CFCR80221 Washer?
If the wash cycle on your Whirlpool Washer isn't starting, check the following: * Ensure the door is fully closed. * Make sure the “ON/OFF” button has been pressed. * Verify the “Start/Pause” button has been pressed. * Confirm the water tap is open. * Check if a “Start delay” has been set.
What to do if my Whirlpool Washer is leaking water?
If your Whirlpool Washer is leaking water, check if the water intake hose has been tightened properly. Also, inspect the detergent dispenser for clogs and ensure the drain hose is properly fastened.
Why is my Whirlpool CFCR80221 not draining or spinning?
If your Whirlpool Washer isn't draining or spinning, it might be because the current program doesn't include the draining function, which needs to be activated manually for certain programs. Also, check if the drain hose is bent or if the drain line is obstructed.
How to stop my Whirlpool CFCR80221 from vibrating during the spin cycle?
If your Whirlpool Washer is vibrating excessively during the spin cycle, ensure that the drum was properly unblocked at the time of installation. Check if the washing machine is level and not squeezed between furniture and the wall.
What to do if my Whirlpool CFCR80221 Washer is not filling with water?
If your Whirlpool Washer isn't filling with water and displays the “h2o” message with a beep every 5 seconds, check that the water intake hose is connected to the tap and not bent. Ensure the water tap is open, the mains water supply hasn't been shut off, and there's enough pressure. Also, verify the “Start/Pause” button has been pressed.
Why is the door locked on my Whirlpool CFCR80221 and the program not running?
The door on your Whirlpool Washer may be locked due to a power breakdown. The program will continue automatically once the mains are available again. Alternatively, the washing machine might be in a standstill, and the program will continue automatically once the cause of the standstill no longer persists.
Why is there too much foam in my Whirlpool CFCR80221?
If too much foam is forming in your Whirlpool Washer, the detergent might not be compatible with washing machines; it should have wording like “for washing machines” or similar. Also, the detergent dosage might be excessive.
Why does my Whirlpool Washer keep loading and draining water?
If your Whirlpool Washer is continuously loading and draining water, ensure the drain hose is installed 65 to 100 cm from the ground and that the end of the drain hose is not immersed in water. Also, check that the drain connector on the wall has an air vent.
General| Brand | Whirlpool |
|---|---|
| Model Number | CFCR80221 |
| Product Type | Washer |
| Color | White |
| Energy Star Certified | Yes |
| Delay Start | Yes |
| Child Lock | Yes |
| Washer Type | Top Load |
To Next Page