Whirlpool FWG71283W User Manual

8
User manual
OPTIONS
FUNCTIONS
! If the selected function is incompatible with the set programme, the incompatibility will be signalled by a buzzer (3 beeps).
! If the selected function is incompatible with another previously set function the function will not be enabled.
CLEAN+
ON/OFF
START/PAUSE
KEY LOCK
FRESHCARE+
TEMPERATURE
SPIN
BLEACHING
INTENSIVE RINSE
START DELAY
KNOB
Clean+ is an option working on 3 dierent levels (Intensive,
Daily and Fast) that are specially designed to set the right
washing action, depending on your cleaning needs:
Intensive : this option is designed for high levels of
dirtiness, removing most stubborn stains.
Daily : this option is designed to remove everyday stains.
Fast : this option is designed to remove lightly soiled
stains.
To switch on the washing machine: press the “ON/
OFF“ button, the “Start/Pause” button light up. To
switch o the washing machine during the wash cycle,
press and hold the button for approximately 3 seconds. If
the button is pressed briey or accidentally the machine
will not switch o.
To switch o the washing machine after programme end:
press the “ON/OFF“ button until the lights go o.
To start the programme, after you have nished
your settings. To pause a running programme. To continue
a paused programme.
To lock the control panel, press and hold the “Key
lock” button for approximately 3 seconds. The symbol
will light up on the display to indicate that the control
panel has been locked (with the exception of the “ON/
OFF“ button). This prevents unintentional changes to
programmes, especially with children near the machine. To
unlock the control panel, press and hold the “Key lock”
button for approximately 3 seconds.
This option enhances washing performance by generating
steam to inhibit the proliferation of the main bad odour
sources inside the machine. After steam phase, the
washing machine will perform gentle tumbling through
slow rotations of the drum. FreshCare+ option starts after
the cycle ends for a maximum duration of 6h and you can
interrupt it at any time by pressing any button on control
panel or turning the knob. Wait around 5 minutes before
door can be opened.
Every programme has a predened temperature. If you
want to change the temperature, press the “temperature”
button. The value appears on the display.
Every programme has a predened spin speed. If you want
to change the spin speed, press the “Spin” button. The value
appears on the display.
If you wish to bleach the laundry, load the washing machine
and set the “Rinse & Spin” programme .
Start the machine and wait for it to complete the rst
water lling cycle (roughly 2 minutes). Put the machine
in pause mode by pressing the “Start/Pause” button,
open the detergent drawer and pour the bleach (observe
the recommended doses indicated on the package) into
the main wash compartment where the partition was
previously mounted. Restart the cycle by pressing the
“Start/Pause” button.
If desired, it is possible to add fabric softener into the
appropriate compartment of the detergent drawer.
By selecting this option, the eciency of the rinse is
increased and optimal detergent removal is guaranteed.
It is particularly useful for sensitive skin. Press the button
once, two or three times to select an additional 1 , 2 or
3 rinses after the standard cycle rinse and remove all
traces of detergent. Press the button again to go back to
the “Normal rinse” rinse type.
To set the selected programme to start at a later time, press
the button to set the desired delay time. The symbol
lights on the display when this fuction is enabled. Upto 24
hours. To cancel the delayed start, press the button again
until the value, ‘‘0‘‘ is shown on the display.
To select and conrm programmes. Turn to
select.
DEMO MODE
This function is only used for sales presentations. By this
you can interact with washing machine and see it working
without water. To enter Demo mode, switch the washing
machine ON and OFF again. Press and hold “Start/Pause”
button, then within 5 seconds press also “ON/OFF“
button and hold both buttons for 10 seconds .
To deactivate this function, switch the washing machine
OFF. Then press and hold “Start/Pause” button, within
5 seconds press also “ON/OFF“ button and hold both
buttons for 2 seconds.

Whirlpool FWG71283W Specifications

General

Brand	Whirlpool
Model	FWG71283W
Category	Washer
Language	English