Whirlpool KR-32 - Page 47

4-19
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE POWER CORD
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
1. Turn off the gas to the range and discon-
nect the power cord from the wall outlet.
2. Pull the range away from the wall so you
can access the power cord on the back of
the unit.
3. Remove the clamp and the ground wire
screws from the power cord.
4. Use a small screwdriver and pry the two
locking arms away from the power cord
connector as you pull out on the connec-
tor.
Clamp Screw
Ground Wire
Screw
Power Cord
Locking Arm
(Pry Out )
Locking Arm
(Pry Out )
Power Cord