Whirlpool KR-32 - Page 48

4-20
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE OVEN DOOR
CAUTION: Do not lift the oven door by its
handle.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
To remove the oven door:
1. Open the oven door to its fully down posi-
tion.
2. Remove the two door stop clips from the
oven door slots.
4. Close the oven door as far as the two pins
will allow.
5. Grasp the sides of the door and lift the door
until it stops, then pull the hinge hangers
out of the slots.
3. Install a pin in the hole of each oven door
hinge hanger.
Door
Pin
Hinge
Hanger
Door
Stop Clip
Hinge Hanger
To reinstall the oven door:
1. Grasp the sides of the door and tilt it back
at a slight angle, then insert the hinge
hangers into the hinge slots as far as they
will go.
2. Rotate the top of the door towards the
range so the hinge hangers fit onto the
support pins.