4-22
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE OVEN DOOR HANDLE & GLASS
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
1. Remove the oven door from the range
(see page 4-20).
2. Place the oven door on a padded work
surface with the front glass facing down.
3. Remove the two top door liner screws.
Top Liner Screws
4. Remove the three bottom screws from the
door liner.
5. Lift the liner assembly off the front glass
and set it aside.
6. To remove the door handle, unhook it
from the top of the front glass and remove
the two door handle screws.
Bottom Liner Screws
7. To remove the front door glass, remove
the two side trim screws. Be careful not to
break the trim near the mounting screw.
Door Handle Screws
Door Glass Trim Screws
To Next Page
Loading...
