4-24
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE OVEN DOOR GASKET
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the gas range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1. Open the oven door to its fully down posi-
tion.
2. Pull the oven door gasket clips out of the
liner holes until all of the clips are re-
moved.
REASSEMBLY NOTE: When you install the
new gasket, make sure that all of the clips are
seated in their liner holes, and that the ends of
the gasket are pushed fully into their holes. Use
the pointed end of a pencil to push the gasket
ends into the holes.
3. Pull the ends of the gasket out of the liner
holes.
End Of Gasket
In Liner Hole
Push End Of
Gasket Into
Hole With
Pencil
Door Gasket
Gasket Clips
To Next Page
Loading...
