OPTIONS AND MODIFIERS
Extended Spin
Use this option to increase the final spin period by 1 minute
during the final spin.
Gentle Spin
Each cycle has a preset spin speed. To reduce the final spin
speed, select the GENTLE SPIN button.
Wash Temp
Each cycle has a preset water temperature setting. To change
the water temperature, select the WASH TEMP button until
the desired setting is illuminated.
Select a water temperature based on the type of load you are
washing. Use the warmest wash water safe for fabrics. Follow
garment label instructions.
The water temperature for all rinse cycles is cold. Cold rinses
save energy.
Temperature Guide
In wash temperatures colder than 60°F (15.6°C), detergents
do not dissolve well. Soils may be difficult to remove.
Auto Temp Control
ATC (Auto Temp Control) electronically senses and maintains
a uniform water temperature. ATC regulates incoming hot and
cold water. The ATC is automatically turned ON when a cycle
is selected. See Preset Cycle Settings table in
“Cycles.”
• ATC works for the wash temperature with Warm and
Cold settings.
• The Cold rinse temperatures depend on the cold water at
your faucet.
Wash Water Temperature Suggested Fabrics
HOT Whites and pastels
Heavy soils
WARM Bright colors
Moderate to light soils
COLD Colors that bleed or fade
Light soils
See “Options and Modifiers” in the Use and Care Guide for
more information on customizing your wash.
Not all Options are available with all cycles.
• See the “Laundry Guide” section of the Use and Care Guide
for an overview of possible options for each Wash Cycle selection.
• If an option is available with a selected cycle, the light for that
option will be illuminated when selected.
• If an option is unavailable with a selected cycle, there will be
a blinking light for that option. It will not illuminate when it
is selected.
Delay Wash
Use this to begin the wash cycle later.
• Select DELAY WASH until the desired time (in hours) shows in
the Estimated Time Remaining display.
• Select START. The countdown to the wash cycle will show in
the display window.
Prewash
Prewash is an 18-minute soak phase that is added before the
main wash. During prewash, there is only a small amount of
tumbling.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or
bleach residue from garments. This option provides an
additional rinse with the same water temperature as in the
normal rinse. You may select or deselect by pressing EXTRA
RINSE.
Wrinkle Release
Use this option to increase the quantity of incoming water and
decrease the spin speed and duration in the rinse period. The
last spin phase will have a lower spin speed and last a shorter
time.
CYCLES
CYCLE
ESTIMATED
TIME*(HR:MIN)
WASH
TEMP
SPIN
SPEED
Normal
Use this cycle for normally soiled cottons and linens.
0:50 Warm High
Quick Wash
To wash small loads of 2-3 lightly soiled garments.
0:30 Warm High
Delicate
Use the cycle to wash sheer fabrics and lingerie.
0:37 Warm Low
Each cycle has a preset Cycle Time and WASH/RINSE TEMP. The preset settings provide the recommended fabric care for
the selected cycle. See chart.
To Next Page
Loading...
