Whirlpool WM1807 - Installation; Prior to Connecting; Safety Instructions; Important Safety Instructions

2 3
INDEX
INSTALLATION
Installation 3
SAFETY
Important safety instructions 4
Trouble shooting guide 5
Precautions 6
ACCESSORIES AND MAINTENANCE
Accessories 7
Maintenance & Cleaning 8
Environmental Hints 8
CONTROL PANEL
Control panel & Display Description 9
GENERAL USE
Standby mode 10
Start Protection / Child Lock 10
Pause or Stop cooking 10
Add / Stir /Turn food 11
Clock 11
COOKING FUNCTIONS
Jet Start 12
Microwave 13
Defrost 14
Mute 15
Auto Cook Menu 16
Soften/Melt 20
Keep Warm 21
Auto Clean 22
ENVIRONMENTAL HINTS
Technical Specications 23
Position the microwave oven at a distance from
other heating sources. For sufficient ventilation,
there must be a space of at least 30 cm above the
microwave oven.
The microwave oven should not be placed in a
cabinet. This microwave oven is not intended to be
placed or used on a working surface lower than 850
mm above the floor.
PRIOR TO CONNECTING
* Check that the voltage on the rating plate corresponds to the voltage in your home.
* Place the microwave oven on a stable and even surface that is strong enough to hold
the microwave oven and the food utensils you put in it. Use carefully when handling.
* Ensure that the space underneath, above and around the
microwave oven is empty to allow for proper airflow.
* Ensure that the appliance is not damaged. Check that the microwave oven door is
closed firmly against the door support and the internal door seal is not damaged.
Empty the microwave oven and clean the interior with a soft, damp cloth.
* Do not operate this appliance if it has a damaged mains cord or plug,
if it is not working properly, or if it has been damaged or dropped. Do
not immerse the mains cord or plug in water. Keep the cord away from
hot surfaces. Electrical shock, fire or other hazards may result.
INSTALLATION
850mm
30cm
Prior to using the microwave for the first time, it is recommended to remove the
protective film from the control panel and the cable tie from the power cord.
NOTE:
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death, fire,
or electrical shock.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.