White 310 - Adjusting Fabric Pressure and Feed Dog Height

ADJUSTING
THE
PRESSURE
ON
THE
FABRIC
AND
THE
FEED DOG
HEIGHT
•
General
Sewing
For
normal
sewing,
except
when sewing
on
very
heavy
and
bulky
fabrics,
the
center
pin
(A)
of
the
pressure
control
should
be
at
its lowest
posi
tion,
with
the feed
dog
height
at the
UP position,
obtained
by
pressing
the
part
of the
feed
dog
height button
to
the right
of the
rotary
hook.
For
special
fabrics, as
mentioned
above,
reduce
the pressure
by half.
To do so,
press
the
outer ring
(B)
of
the pressure
control,
then press
the
centre
pin
(A)
down
again,
to the half-way
position.
.
Pressure
on
Feed
dog
Fabric
fabric
height
Ordinary
fabric
with
little
elasticity:
Heavy
and
bulky
fabrics
Half
Medium
and light
weight
fabrics
Full
(Up)
Very stretchy
fabrics and
knits:
Heavy
and
bulky
fabrics
Half
Medium,
light
weight
and
.
Full
(Up)
sheer
fabrics.
• Mending
and
Darning
So
as to
be able
to
move
the
fabric
freely
in
any direction
for
darning
and
mending,
release
the
center
pin
(A)
completely
by
pressing
down
on
the
outer ring
(B).
Press
the
7j.
mark
on
the
feed
dog height
button
so that
the feed
clog
drops
well below
the
needle
plate.
To
raise the
feed dog
to its
normal
height,
press the
/‘j
(rip)
mark on
the
button.
A)