White 445 - Connecting Foot Controller and Power Cord

Connecting Foot Controller
and Power Cord
Connect foot controller апа
power cord (1 2
Before plugging in your machine,
be sure that voltage is same as
that of your machine. (written on
a plate at back of machine)
Ж Specifications vary from countrv
to country.
Switch on power to put on
machine and turn on sewing
light.
Always switch off or unplug
machine when not in use.
The more you press foot controller,
the faster the machine runs.
Changing Foot
Raise presser foot lifter ©.
Set needle in the highest
position by turning handwheel
towards you ®©
Remove foot by loosening screw
with screwdriver
Replace new foot and tighten
screw.