White 445 - Drop Feed Lever

Inserting Bobbin
Place bobbin in its case with
thread running in direction of
arrow.
Guide thread into slot (а) of
bobbin case
Pulling thread to left, bring it
under tension spring then to
delivery eye (b).
==
loosen
РЕ: 138
Adjusting Lower Tension
To test bobbin tension, hang and
shake bobbin case as shown.
At proper tension bobbin case
will gradualy drop а small
amount.
To adjust tension, turn adjusting
screw with small screwdriver.
Raise needle in the highest
position.
Leave end of thread of about 10
cm (4") from bobbin case.
Take hold of latch and push
bobbin case into hook.
Release latch when bobbin case
is fully inserted
Drop Feed Lever
The lever is on right side of hook
To lower feed dog, move lever
down to da position.
This position.is for button sewing,
darning and embroidery.
For normal sewing, move lever
up to AA DOsition.