White 445 - Page 7

Push back to fold handle.
Pull out spoolpin.
Put a spool on spoolpin.
Draw thread from spoolpin
through thread guide and pre-
tension device, following numb-
ers © @ and 3)
Wind thread clockwise around
bobbin several times.
Push bobbin on to spindle.
Holding handwheel with your left
hand disengage handwheel by
unscrewing stop motion knob
correction
Push bobbin to right and press
down foot controller
Machine stops automatically
when winding is full.
Push bobbin to left.
Take off bobbin from spindle
and cut thread.
Retighten stop motion knob.
If bobbin is wound unevenly
as shown, open face cover and
loosen set-screw of the guide for
bobbin winding, by using screw
driver and adjust height.