White 445 - Bobbin Winding

Changing Needle
Set needle in the highest
position by turning handwheel
towards you.
Loosen needle clamp screw and
take out needle.
With flat face away from you,
insert a new needle into groove
of needle bar.
Push needle until it reaches
stopper à) and tighten needle
clamp screw firmly.
Always use a straight needle with
a sharp point.
Using defective or worn needles
not only causes stitch skipping,
breakage of needles or snapping
of thread; it also can damage
hook and needle plate.
Proper needle
cz =<
Bobbin Winding
Set needle іп the highest
position by turning handwheel
towards you.
Open shuttle cover.
Open latch of bobbin case and
take it out.
Close latch of bobbin case and
bobbin comes out easily.