White 535 - Winding the Bobbin

Disengage
hand
wheel
(5,
Fig.
3),
from the
stitching
toward you
or counter
clockwise.
Place
a
spool
of thread
on one of
the
spool
pins.
guide on
arm
and
down
through
tension disc(9, Fig.
mechanism
by turning clutch (6,
Fig.3)
Lead
thread
through
the
upper thread
5,)at base
of machine. Run end of
threcid
through
a
hole in
bobbin edge
(left
flange
and from inside out) and place
bobbin on
spindle of bobbin winder
(7,
Fig.
4,) fitting
the
notch bobbin over small pin
on spindle.
Push bobbin winder against hand wheel.
Hold
thread end loosely
and
start
machine
slowly.
Bobbin
will
stop winding when
it is filled.
Turn
clutch away from
you until
sewing
mechanism is
again engaged so that
needle
moves when
you turn
the hand
wheel.
Break
off loose thread
end used
to start
the
winding
and
thread
bobbin as stated on
Page
6.
Fig,
3
Fig.
4
5
WINDING THE
BOBBIN
‘I.—
Fig.
5