2010 Edition 1 Page 9
WHYTE Service Manual
3.0: PREPARATIONS FOR RIDING
3.1: MAKING ADJUSTMENTS
Please refer to the specific component manufac-
turers manual or published technical information
about adjusting the components on your Whyte
bike. Instructions may be downloaded from the
relevant manufacturer’s internet site, as shown in
the table to the right.
CAUTION! If you are uncertain in any
way, about making adjustments to any
components on you Whyte bike, then DO
NOT RIDE YOUR BIKE. Contact your
Whyte dealer who will be able to advise
you on how to go about setting up you
Whyte for riding, and or making adjust-
ments to the components fitted to your
Whyte.
3.2: WHYTE GETTA-GRIP SEAT CLAMP
The Getta Grip seat clamp design is a patented design to allow adjustment of the saddle
height by either the use of a QR Lever, or bolt-up method. This manual covers both styles
of clamps.
Alex Rims www.alexrims.com
Continental www.conti-online.com
CST www.csttires.com
DT www.dtswiss.com
Easton www.eastonbike.com
Fi:zik www.fizik.it
FSA www.fullspeedahead.com
Fulcrum www.fulcrumwheels.com
Formula www.formulahubs.com
Fox www.foxracingshox.com
Hayes www.hayesdiscbrake.com
Hope www.hopetech.com
Mavic www.mavic.com
Maxxis www.maxxis.com
Shimano www.shimano.com
SRAM www.sram.com
Sun Ringle www.sun-ringle.com
Tektro www.tektro.com
Thomson www.lhthomson.com
VP www.vpcomponents.com
WTB www.wtb.com
TH www.thindustries.com.tw
To Next Page
Loading...
