Whyte KYNAMIC - Post-Crash Inspection

02 - RIDE INFO 2.4 After a Crash
AFTER A CRASH
Check yourself for injuries. Take care of them as best you can. If necessary,
seek medical help. An apparently minor incident could have major
implications later on.
Ensure a thorough check of the complete bike is carried out before riding the
bike after a crash/fall. Damage might be obvious like a cracked frame, forks,
or bent handlebars. Less obvious damage like bent or twisted controls on the
handlebar can affect handling of the bike and will need to be rectied. Please
go through the ‘Pre-Ride’ checks supplied in this manual. Carefully examine
all areas of the frame, forks, and rims for any dents, cracks or deformations. If
you nd any signs of damage to the frame, forks, or rims then do not ride the
bike. Consult your Whyte retailer to have the bike thoroughly inspected before
riding the bike again.
Check the seat, seat-post, stem, and handlebars are still in the correct
orientation. NEVER try to correct the position by force. Loosen xings/bolts
with the correct tools and reposition before re-tightening (Ensure you refer to
the specied torque settings).
Check both wheels are securely tted in the right position in the frame and
fork. Lift the eBike at both the front and rear to test the wheels rotate freely.
Make sure there are no dents or deformations to the rims. Ensure the wheel
runs true with no interference from the frame. Be sure to check over brake
alignment with discs and pads as this may have been altered in the crash.
Failure to carry out these checks before riding puts the rider at risk.
WARNING: Aluminium components when deformed can break
unexpectedly. If any of your Whyte bicycle components have been
deformed or bent after a fall then the bicycle is unsafe to ride.
Please ensure damaged parts are replaced and correctly installed. If
there is any doubt do not ride your bicycle and contact your Whyte
retailer for support. .
13
WARNING: A collision or impact can cause serious damage to your
bicycle and its components, causing them to malfunction or wear out
prematurely. Malfunctions can occur suddenly and without notice,
causing you to lose control of your bicycle and suffer serious injuries.
If you discover any damage to your Whyte bike or its components, STOP using
the bicycle immediately!
Even if you cannot visually observe any damage, pay close attention to the
sound of your bicycle when riding. Unusual noises or riding vibrations can be
a clear sign of damage and you should stop riding immediately. Contact your
Whyte retailer who will be able to correctly diagnose the problem.
WARNING: Carbon composite components, including frames, wheels,
handlebars, stems, cranksets, brakes, etc. which have sustained an
impact must not be ridden until they have been disassembled and
thoroughly inspected by a qualied mechanic.