Whyte KYNAMIC - HMI Bar Mount Controls; Powering the System On and Off

20
05 HMI BAR MOUNT
5.1 On/Off
CAUTION - Before your ride:
• Regardless of your experience level, you should read the User
Manual carefully and carry out all important safety checks.
• The eBike system can only operate when the battery is sufciently
charged.
Product Features
All illustrations of bike parts except for the drive unit, on-board computer
(including operating unit), speed sensor and the corresponding holders are a
schematic representation and may differ on your eBike. The numbering of the
components shown refers to the illustrations on the graphics to the right.
Operation Requirements
Your eBike system can only be activated when the following
requirements are met:
– A sufciently charged battery is inserted (see battery operating instructions).
– The speed sensor is connected (see drive unit operating instructions).
Power On/Off
Press and hold the power button (1) to turn on/off.
Start up logo will be displayed for 3 seconds after initiating power to the
controller. Then the home screen will be displayed.
1
HMI control unit
Dropper Post Lever
(Not tted to all bike
specications)