Kunststoffschweißtechnik
WIDOS Einsteinstr. 5 Telephone +49 (0) 71 52 / 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Telefax +49 (0) 71 52 / 99 39 - 40
E-mail: info@widos.de Internet www.widos.de
18.07.2013 Working Instructions WIDOS ESI 4000 Page 33 of 37
6. Maintenance / Storing / Transport
Goal of the chapter is:
Keeping of the nominal state and the operation capacity of the device.
Increasing of the efficiency by avoiding non-planned outage.
Efficient planning of the maintenance works and the maintenance tools.
Immediately replace damaged parts.
Only use WIDOS spare parts for reparation works.
Prescribed maintenance and inspection works are to be carried out in due time.
It is recommended to execute inspection works every year.
These works are to be carried out by company WIDOS GmbH or by a contractual
partner.
Handle the device with care.
The housing may only be opened by qualified WIDOS personnel or by authorized service
partners.
Regularly check the contact plugs on their tight fit, always observe matching connecting
contacts.0
Always remove plug from power socket not using the cable.
6.1. Cleaning and care
The device ESI 4000 is to be cleaned with a humid and soft cloth.
Never put the device under water or hose down with water.
6.2. Transport and storing
The device ESI 4000 should be carried and
stored in the supplied transport case or
transport crate in order to protect against dirt
and humidity.
In case of a welding the device should be carried at the intended carrying handle, never lift it
up at the cables
6.3. Waste management
The device is to be disposed of in an appropriate and environmentally sound
manner after its service life has elapsed, respecting customary waste
management laws.
To Next Page
Loading...
