Kunststoffschweißtechnik
WIDOS Einsteinstr. 5 Telephone +49 (0) 71 52 / 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Telefax +49 (0) 71 52 / 99 39 - 40
E-mail: info@widos.de Internet www.widos.de
18.07.2013 Working Instructions WIDOS ESI 4000 Page 6 of 37
1. Product description
This chapter gives important basic information about the product and its prescribed use.
All technical details of the machine are put together as a general arrangement.
1.1. Application and intended use
The WIDOS ESI 4000 was especially designed for the use on building sites in order to weld
PE and PP pipes with all common socket types on the spot.
Any other use exceeding this is to be considered non-intended.
For damages resulting from it, the manufacturer cannot be held liable.
The risk is exclusively on the user’s side.
Also part of the purpose-oriented use is
respecting all the indications of the working instructions and
performing the inspection and maintenance works.
1.2. Safety measures
In case of wrong use, wrong operation or wrong maintenance the machine itself or products
being in the surrounding can be damaged or destroyed.
Persons being in the endangered area may be injured.
Therefore these working instructions have to be thoroughly read and the corresponding safety
advices must be necessary adhered to.
1.3. Conformity
The machine corresponds in its construction to the valid recommendations of the European
Community as well as to the European standard specifications.
The development, manufacturing and mounting of the machine were made very carefully.
1.4. Designation of product
The product is designated by two signs at the frame.
The type-labels are fixed on the control unit and on the basic machine.
They contain the type of the machine, the serial number, and the year of construction.
To Next Page
Loading...
