Wiedenmann Super 600 - Page 49

All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
49
8.0. Service
8.3. Maintenance and inspection list
Multifunction head
Area
Maintenance measure
Maintenance
interval
Gearbox
Change the gear oil
For the first time
Further intervals
(see 8.7.)
100 hrs.
500 hrs.
Rotor bearing
Lubricate both outer flange
roller bearings and the upper
flange roller bearing
(see 8.4.1. and 8.4.2.)
100 hrs.
Front supporting
rollers
Lubricate the guide bushing
of the height adjustment
(see 8.4.3.)
100 hrs.
Lubricate the wheel bearing
(see 8.4.4.)
100 hrs.
Check the air pressure and
correct if necessary
As needed
Cardan shaft
Lubrication intervals
according to the
manufacturer’s instructions
8 hrs.
V-ribbed belt
drive
Check the tension of the v-
ribbed belt, tighten if
necessary (see 8.8.)
First inspection
Further inspections
20 hrs.
100 hrs.
Linkage points
for control guide
No maintenance as plastic
plain bearings are used
Work tools
Check the shape of the
cutting blades
As needed
Check the shape and length of
the verticutting knives
As needed