EasyManua.ls Logo

Wiggo WO-E505R - Troubleshooting

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Turn part A in figure 1 into the direction of the arrow.
Removal of the oven door
Push forward in the direction of the arrow and pull the oven door
towards you, as shown in the figure 3.
As shown in the figure 2, place part A into the part B.
Hot surfaces can cause burns!
1.Open the oven door.
To avoid electric shock, unplug the power cord and allow it to cool before using oven lamp is going to be
replaced.
Oven lamp is a special electric lamp resistant to 300oC. For TLE lamp specifications, see Technical
specifications, page 3.
Oven lamps can be supplied by the Authorized Service Centers. Position of the lamp
may differ from the one shown in the figure.
1. Switch off the mains voltage.
2. Turn the glass cover counterclockwise and remove.
3. Turn the oven lamp counterclockwise and replace it with the new one.
4. Place the glass cover back in place.
Check whether the earthed plug is properly connected to the socket.
Check the fuses in the meter cupboard. If it is turned off turn it back on.
Mains voltage may be fluctuation. Unplug and plug again.
If steam goes out during oven operation it is normal. This is not an error.
The metal parts may make a noise due to the expansion at the time of heating. It is not a cause of failure.
No power. Control whether power is available at home and check the fuses in the fuse box. If required, engage
the fuses again.
May be timer has not been set in case of versions with timer. Set the timer or bring it to the manual (hand) sign.
Possibly function and/or temperature button has not been set. Set the function and/or temperature button.
No power. Check if there is power. Check the fuses in the meter cupboard. Replace or reset the fuses if
necessary.
For versions equipped with timer, the timer is not set. Set the time or bring it to the manual (hand) symbol.
If the problem is not resolved after following the instructions in this section, please consult your dealer or
authorized service center. Do not attempt to repair the defect yourself to repair.
Does your oven have a round lamp:
Product does not work..
Steam goes out when the oven is working
Ringing sound when the product gets hot and cold.
Furnace does not heat.
Oven does not heat up.
Troubleshooting7 |