WIKA CPG1500 - Page 16

16 WIKA operating instructions, model CPG1500
EN
14161966.06 03/2024 EN/DE
4. Design and function
Pos. Symbol The symbol is displayed on:
3
Battery symbol
...
Battery status 100 % ... 40 %
■
Outline is displayed continuously
■
One segment is displayed for each 20 %
Battery status 20 %
■
Outline is displayed continuously
■
New batteries must be used, see chapter
8.2.2 “Battery replacement”
4
Pressure indication
The 5 ½-digit 7-segment display always indicates the current
pressure value.
If the pressure value is no longer up to date, lines will be displayed
(in low-power mode over 10 s).
Values are always indicated with a decimal point.
5
Matrix field serves as menu and secondary display
The matrix field consists of 4 x 21 cells (rows x columns) and
serves as a menu and secondary display.
10
Bar graph indicates the current pressure graphically
The bar graph consists of 20 segments and two end points at the
front and rear ends. The bar graph indicates the current pressure
proportionally to the measuring range. If the measuring range has
been underrun, the front point lights up; with an overrun, the rear
point lights up.
11
Lock symbol
It is locked, if the [ZERO/▲] or [MENU/◀▶] buttons have been
locked via WIKA-Cal and must be pressed manually.
Password protection is done only via WIKA-Cal calibration software
or via the free WIKA-DCS software.
12
Bluetooth
®
symbol (only for instruments with Bluetooth
®
option)
■
Symbol is blinking: Bluetooth
®
is active but not connected
■
Symbol is lit continuously: Bluetooth
®
is active and connected
13
Tare TARE function active
→ For further information, see chapter 6.2.4 “Tare”
Further definitions
“XXX” Menu XXX is accessed
[XXX] Press XXX button
XXX Menu will be displayed