WIKA CPG1500 - Page 61

61WIKA operating instructions, model CPG1500
EN
14161966.06 03/2024 EN/DE
9. Dismounting, return and disposal
9.1 Dismounting
WARNING!
Physical injury
When dismounting, there is a danger from hazardous media and high
pressures.
▶
Wear the requisite protective equipment.
▶
Observe the information in the material safety data sheet for the
corresponding medium.
▶
Disconnect the test and calibration installations once the system has
been depressurised.
▶
Wash or clean the dismounted instrument (following operation),
in order to protect persons and the environment from exposure to
residual media.
1. Switch off the instrument.
2. Loosen the digital pressure gauge with a spanner or torque wrench, using the
spanner flats.
3. Screw out the digital pressure gauge by hand.
4. Clean the digital pressure gauge as required, see chapter 8.3 “Cleaning”.
9.2 Return
Strictly observe the following when shipping the instrument:
■
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, bases, solutions, etc.) and must therefore be cleaned before
being returned, see chapter 8.3 “Cleaning”.
■
When returning the instrument, use the original packaging or a suitable transport
packaging.
With hazardous substances, include the material safety data sheet for the
corresponding medium.
To avoid damage:
1. Wrap the instrument in an anti-static plastic film.
2. Place the instrument, along with the shock-absorbent material, in the packaging.
3. If possible, place a bag, containing a desiccant, inside the packaging.
4. Label the shipment as carriage of a highly sensitive measuring instrument.
Information on returns can be found under the heading “Service” on our
local website (return application).