Wilfa VOLO - Page 12

12
ENEN
PREPARING LATTE MACCHIATO
AND CAPPUCCINO
1. Install automatic milk froth system.
2. Fill milk in the milk container and close
the lid.
NOTE: Always use cold milk (approximately
5°C/41°F) with a fat content of at least 3% to
ensure an optimal frothing result.
3. Switch on the appliance by pressing the
ON/OFF button. Make sure the drip tray
is correctly placed under the coffee spout,
and that the water tank is full and correctly
placed. The appliance will perform auto-
rinsing for a small cup of water, you can stop
it by pressing Quick Clean/Hot Water button
.
4. Place a cup under the coffee spout. Press
the Latte Macchiato button or the
Cappuccino button . The button lights
indicating coffee preparation. It will rst
dispense milk then coffee.
5. Preparation will stop automatically. If you
want to stop before, press the button again
during the operation.
6. Remove milk container from machine and
put it in the fridge.
7. After use, see “Cleaning and maintenance”
to clean the automatic milk froth system and
milk container.
WARNING:
• Steam and hot milk may spray out of the
nozzle when starting to brew.
• Place the connecting rubber hose around
the container lid after use. Do not let it fall
freely to prevent milk spraying out due to
pressure difference.
illumination under spout will light up
indicating that the appliance is preparing
the cup of coffee.
6. Preparation will stop automatically. If you
want to stop dispensing coffee during
operation, press the button again.
7. When the appliance is back to standby
condition, the coffee is ready.
TIP: Espresso button is with higher coffee
intensity. Both coffee button volumes can be
adjusted (see “Adjusting Coffee/Hot Water
Volume”).
NOTE: Use Hot Water function to clean inside
of the coffee maker before rst use.
PREPARING TWO CUPS OF
ESPRESSO OR LUNGO
You can prepare two cups of espresso or lungo.
1. Put one large cup under the spout or two
small cups under each side of spout.
2. Press button. The button will light
with Espresso and Lungo buttons. If you
want to cancel, press x2 button again and it
will stop.
3. Choose your coffee avor by pressing
Espresso or Lungo button The
indicator lights up indicating the appliance
is preparing the cup of coffee. Two cups of
coffees will be dispensed consecutively one
after another.
4. Preparation will stop automatically. If you
want to stop dispensing coffee during
operation, press the button again.