Wilfa VOLO - Cleaning Water Tank

17
ENEN
NOTE: When lights up or blinks, the
coffee ground container is missing, or it needs
to be emptied, the drip tray must be empty
and dry.
If you empty the tray while the machine is off,
the icon may appear even if the tray is not full.
CLEANING THE MILK FROTH
SYSTEM
Note: It is important to do this step maximum
30 minutes after using the milk frother. This is
to keep the milk frother in a good condition.
1. Take out the spout cover and remove the
milk frother.
2. Take apart the milk frother and clean with
fresh water. You can use the bristle of the
brush to clean the plastic part to ensure
there is no milk residues left.
3. Assemble the milk frother, and insert it into
the coffee machine.
CLEANING THE MILK CONTAINER
AND CONNECTION TUBE
It is important to perform this step daily to
make sure the automatic milk frother running in
good condition.
1. Empty the milk container and wash with
fresh water. Remove the connection rubber
and container tube from lid. After cleaning
and drying, assemble the parts to the lid.
Make sure it is correctly assembled.
2. Clean both ends of connection tube with
fresh water. Make sure the hole on tube
connector as below is clean. You can use
needle or bristle of the brush to clean the
ends.
CLEANING WATER TANK
1. Lift the water tank out of the machine and
rinse with fresh water.
2. Fill it with drinkable water up to the Max
level. Put it back in the machine.