Wilfa VOLO - Troubleshooting

18
ENEN
PROBLEM CAUSE SOLUTION
The appliance does not
work.
The appliance is not connected
to the power supply.
Plug in and press the Power
ON/OFF button.
Check the cable and the plug.
No or delayed response
in several trials of pressing
the function buttons on the
panel.
Appliance is under an electro-
magnetic interference.
Dirt on the panel.
Unplug the appliance. Restart
after few minutes.
Clean the panel with the cloth
provided.
The coffee is not hot
enough.
The appliance is not warm
enough.
Rinse the appliance at least 3
times before making the coffee.
The coffee cannot come out
from spout.
Empty system function may be
used before.
Press the Hot Water button
until water can come out from
spout.
Coffee has no crema. Coffee bean is not fresh. Change or use appropriate
brand of coffee bean.
The touch buttons are not
sensitive.
Not pressing the touch buttons
from the front direction of the
appliance.
Press the lower bottom part of
the icon of the touch button
from the front direction of the
appliance.
The appliance takes too
long time to warm up.
Excessive scale has built up. Descale the appliance.
The water tank is removed/
the water level is very low in
the water tank but have
not alert.
The area near the water tank
connector is wet.
Wipe the water around the
water tank connector.
Internal drip tray is lled with
a lot of water.
Coffee powder is too ne which
block the water to come out.
Adjust the coffee neness to
bigger dots during grinder
operation.
Coffee is delivered too
slowly or a drop at a time.
Coffee powder is too ne which
block the water to come out.
Adjust the coffee neness to
bigger dots during grinder
operation.
Lack of bean indicator
ashes but there is still a lot
of coffee bean inside the
container.
Internal coffee powder outlet is
blocked.
Follow the steps in “Cleaning
Coffee Powder Outlet”.
TROUBLESHOOTING