Wilfa VOLO - Cleaning the Appliance

16
ENEN
unit and dispense from spout.
3. Around a cup of water will be dispensed. It
will stop automatically, or you can press the
Quick Clean/Hot Water button to stop.
CLEANING THE APPLIANCE
1. Disconnect the power cord from the mains
supply outlet.
2. Pour away all water in both the internal and
external drip trays.
3. Use a damped cloth or non-scratching
cleaner to clean the water stains on the
appliance. Make sure it is dry before
reinstalling it.
IMPORTANT: Never use any abrasive, vinegar
or descaling agents not included in the box to
clean the appliance.
CLEANING COFFEE POWDER
OUTLET
Coffee powder may stick on the wall of powder
outlet for appliance after used a long period
of time. It is suggested to clean the outlet by
following steps to ensure that coffee powder
can deliver to the brewer.
1. Push the service
door.
2. Take the door out.
3. Press the release
knob on the
brewer.
4. Take the brewer
out.
5. Rinse the brewer
in running water.
Let it dry comple-
tely.
6. Use the cleaning
brush to clean
the powder outlet
and remove any
coffee grounds or
residues.
7. Use a cloth to
clean inside of the
machine thoroughly.
Dry completely
before closing the
side door.
NOTE:
When lights up, it indicates that the
brewer is missing/installed improperly.
When is ashing, it indicates that the
service door is missing/installed improperly.
When is ashing or lights up, the coffee
ground container is missing or full.
CLEANING DRIP TRAY AND COFFEE
GROUNDS CONTAINER
Empty and clean the drip tray every day.
1. Pull the external drip tray out of the
machine. Empty the water left in drip tray
and rinse with fresh water. Dry it afterwards.
2. Slide open internal drip tray and coffee
ground container. Empty the coffee ground
container and rinse with fresh water. Dry it
afterwards. Do not insert it while it’s still wet.
3. Put back the coffee grounds container in
internal drip tray.
4. Insert the external drip tray at its original
position.