Night Scan Chief
Err 2,13 Pan Right
Limit
The left pan
photosensor was
made before the
right photosensor
indicating wrap
around or the right
photosensor is
linear or defective
Check to make sure the
pan flag is not located in
between the two
photosensors. If it is,
slowly move the RCP
head by hand (with
power off) until it is in the
proper position.
Readjustment of the flag
may be necessary to set
the proper home
position. If the flag is not
in between, replace the
RCP board
Err 2,14 Pan Left Limit The right pan
photosensor was
made before the
left photosensor
indicating wrap
around or the left
photosensor is
linear or defective
Check to make sure the
pan flag is not located in
between the two
photosensors. If it is,
slowly move the RCP
head by hand (with
power off) until it is in the
proper position.
Readjustment of the flag
may be necessary to set
the proper home
position. If the flag is not
in between, replace the
RCP board
Err 2,15 Tilt Limit
Overlap
Both tilt
photosensors
appear to be
blocked
simultaneously
Foreign material in one
of the photosensors or
faulty photosensor.
Check to make sure
there is no foreign
material in the
photosensors. Clean
with a soft cloth. If this
does not get rid of the
fault, replace RCP board
Revision 1 4-16
To Next Page
Loading...
