Installation
5-2 WILO EMU 3.0
Installation
The following information should be taken into consideration when installing the machine:
- This work may only be carried out by qualified personnel. Electrical work may only be carried
out by qualified electricians.
- Lift the machine by the handle or lifting eyelets, never by the the power supply cable. When
assembling with chains, they must be connected with a shackle to the lifting eyelets or the
carrying handle. Fastening devices must have official approval.
- Please observe all guidelines, rules and legal requirements for working with and underneath
heavy suspended loads.
- Wear the appropriate protective clothing/equipment.
- If there is danger that poisonous or asphyxiating gases may collect, then the necessary
counter-measures should be taken.
- Please also observe all accident prevention guidelines, trade association safety guidelines and
the advice contained in this operating and maintenance manual.
- The coating of the machine is to be examined before installation. If defects are found, these
must be eliminated.
An intact coating is necessary for the best possible protection from
corrosion.
Danger of falling!
Installation work for the machine and its accessories is performed
directly on the edge of the basin. Carelessness or wearing inap-
propriate clothing could result in a fall. There is a risk of fatal
injury! Take all necessary safety precautions to prevent this.
To Next Page
Loading...
Need help?
General
