en
Installation and operating instructions • Isar BOOST5 • Ed.06/2024-05 11
2.6 Scope of delivery
Fig.4: Scope of delivery
• Pressure-boosting system
• 2 G1" hydraulic connections
• Handle grip for discharge connections
• Gaskets
• Installation and operating instructions
3 Application/use
3.1 Intended use
Wilo-Isar BOOST5 is an automatic pressure-boosting system with variable speed function
including:
• a highly efficient self-priming electric pump,
• a diaphragm expansion tank,
• pressure and volume flow sensors,
• a non-return valve in the suction port.
The pressure-boosting system is designed for increasing the pressure of clean water in res-
idential buildings and for irrigation, sprinkling in agriculture.
Water is supplied from wells, springs, tanks or the municipal water supply network.
NOTICE
• Observe local regulations for all drinking water applications.
The WRAS and ACS certificate is available for all Wilo-Isar BOOST5 pressure-boosting sys-
tems.
3.2 Improper use
Only for DE:
The product must not be used for drinking water applications within Germany. Connection
to the municipal water supply network is not permitted.
4 Transportation and storage
4.1 Delivery
• After delivery, check product and packaging for defects (damage, completeness).
• The transport company or the manufacturer must be notified of any defects the day the
shipment is received, and the damage noted on the freight documentation.
Claims cannot be asserted if the notification of defects takes place at a later date.
4.2 Transport
CAUTION
Damage to property due to wet packaging!
Wet packaging may tear. If unprotected, the product may fall on the
ground and be irreparably damaged.
• Carefully lift wet packaging and replace it immediately!
1. Only transport the product in the packaging provided.
2. If the outer packaging is damaged or no longer present, apply suitable protection from
humidity and dirt.
3. Remove the outer packaging only once the system is on site.
To Next Page
Loading...
