Pipe
Pipe
Union
Union
TRANSPORTAION AND INSTALLATION
●
Handle the pump with care.
Do not drop.
●
The permitted voltage fluctuation is within 10%
of the rated voltage. Otherwise contact a power
company.
●
The pump should not be connected directly to
public waterworks. Permission from the authority
should be granted. This could shorten the life of
the pump.
●
When the pump is used for
drinking water, a water purifier
must be installed.
※ The pump has no
purification ability.
●
When installing the pump,
make waterways to prevent
damage caused by water
leakage. Pay special
attention to a
basement, kitchen, and attic.
Damage may occur.
waterway
●
Set an anti-vibration plate
to absorb the vibration
of the pump.
●
Install unions on the
suction side and
discharge side of the
pump for convenient
maintenance and
repair.
CAUTION!
●
Connect the earth wire before
operation to prevent electric shock
when the electric insulation is faulty.
●
Never get the power plug strained
with water, to prevent electric shock.
embed a cooper plate
o
r rod deeply in moist ground.
m
ore than 75cm
※
NOTE!
• Disconnect the power supply
before connecting the earth wire.
• Gas pipe must not be connected
with earth wire. Otherwise
an explosion may occur.
m
ore than 75cm
Gas Pipe
Earth wire
●
Minimize the number of elbows to prevent water leakages in the piping
and to decrease water resistance.
●
Set an alarm system to notify
the malfunction of the pump.
●
Don’t expose the pump
to direct sunrays or
to rain, otherwise
faulty parts or an electric
shock may be caused.
7
To Next Page
Loading...
Need help?
General
