18 Wilo SE 03/2017
en
Constant speed
Constant speed I II III:
• Select the setting range of the constant speed.
• Select speed stage I II or III.
The LED display shows the set speed c1, c2 or c3
according to the characteristic curve.
Completing the
setting
• Do not rotate the operating button for 2 seconds.
• LED display flashes 5 times and changes to the cur-
rent power consumption in W.
8 Decommissioning
Shutting down the
pump
Shut down the pump immediately in case of damage to
the connecting cable or other electrical components.
• Disconnect the pump from the power supply.
• Contact Wilo customer service or a specialist technician.
9 Maintenance
Cleaning • Carefully remove soiling from the pump on a regular
basis using a dry duster.
• Never use liquids or aggressive cleaning agents.
Pump Number of square metres of heated space in m²
Yonos PICO…/1-4 m - 80 120
Yonos PICO…/1-6 m 80 150 220
Yonos PICO…/1-8 m > 220
H+H-
NOTE
All settings and displays are retained if the power
supply is interrupted.
To Next Page
Loading...
