10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Installing a Wilson Electronics Signal Booster
Select a location to install the signal booster that is away from
excessive heat, direct sunlight, moisture and that has proper
ventilation. Do not place the signal booster in an air-tight
enclosure.
Recommended installation locations for in-building signal boosters
are:
• On a shelf
• In a closet
• Near a power outlet.
Note: It is important to have adequate air ventilation. Maintain
at least 6 inches of clearance from surrounding objects. Run the
outside antenna cable to the signal booster and attach it to the
connector labeled “outside antenna” on the signal booster. Run
the inside antenna cable to the signal booster and attach it to the
connector labeled “inside antenna” on the signal booster.
Note: Be careful when
plugging the connector in to
avoid bending the center pins
on the connectors.
DB Pro™
To Next Page
Loading...
