EasyManuals Logo

Wilson Electronics SignalBoost User Manual

Wilson Electronics SignalBoost
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
4
Installing the Antenna
To receive the best cell signal, select a location in the center of the vehicle’s roof at least 12
inches away from any other antennas and free of obstructions.
The antenna must be installed vertically.
Signal performance will be degraded if the
antenna is not vertical.
The antenna cable may be run through the
door to the amplier.
The antenna cable is small enough to easily
tuck under the door seal or plastic molding.
For a more professional-looking installation,
the antenna cable may be run under the
door seal. Carefully pull down the door
seal. Run the cable through the seal
and push the seal back into place. This
prevents constant wear and tear on the
cable as the door opens and closes.
Carefully
Pull Down
Door Seal
Run Cable
Under
Seal
Tuck Cable
Under Seal
Vehicle Installation
Warning: The mobile antenna used
with this amplier must have a separation
distance of at least 8 inches from all persons.
!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wilson Electronics SignalBoost and is the answer not in the manual?

Wilson Electronics SignalBoost Specifications

General IconGeneral
BrandWilson Electronics
ModelSignalBoost
CategoryAmplifier
LanguageEnglish

Related product manuals