6
Option 2 - Adhesive Bracket
Clean the area where the bracket is to be
mounted with rubbing alcohol and a soft
cloth. Allow to dry.
Peel the backing to expose the adhesive
and press the bracket onto the desired
location in the vehicle. Note: be sure
the bracket is positioned vertically, not
horizontally.
Allow the adhesive to cure for 24 hours
before you attach the cradle.
Note: Once the cradle is attached, you can
adjust the angle of the adhesive bracket
by applying gentle pressure to the top or
bottom of the cradle.
Option 3 - Adhesive/Screw Swivel
Bracket
Clean the area where the bracket is to be
mounted with rubbing alcohol and a soft
cloth. Allow to dry.
For an adhesive mount, peel the backing
to expose the adhesive and press the
bracket onto the desired location in the
vehicle. Allow the adhesive to cure for 24
hours before you attach the cradle.
For a screw mount, use an ice pick or awl
to punch through the adhesive and expose
the four screw holes in the bracket. You
must provide the screws of an appropriate
size for your particular application. Using
the bracket as a template, mark the
locations for the screws as shown, drill pilot
holes and attach the bracket with screws.
Once the cradle is attached, you can
loosen the knurled wheel and swivel the
hook to the desired angle, then re-tighten
the wheel.
Attaching the Cradle
Once you have installed the mount in the desired location, attach the cradle by aligning
the rectangular hole on its back with the hook on the mount. Grasping the sides of the
cradle, slide it downward approximately ¼ inch into place.
For best mounting results and long-
term performance, we suggest that
you choose a at smooth surface
like the console area of your vehicle
between the two front seats. If this is
not available in your vehicle, you may
mount the cradle on the front of the
dashboard.
If mounting the cradle on a sloped
area of the dashboard in your vehicle,
please note that gravity may affect
the adhesive over time. Use the
screw mount for a more permanent
attachment.
To Next Page
Loading...
Need help?
General
